Gm tech 2 no communication showing error

#GM TECH 2 NO COMMUNICATION SHOWING ERROR SOFTWARE#

See the chapter Parameters for the parameter that requires a restart of the drive.ДЇunction not available in this type of device Restart the drive to activate the parameter functionality. Only displayed by the commissioning software.ДЄ parameter modification requires the drive to be powered off and on.

Parameter changed that requires a restart of the drive The 'First Setup' (FSU) was not run at all or not completed. Value in additional error information shows the Modbus register address of the parameter where the initialization error was detected.Д«asic configuration of drive required after factory setting System error detected: No bootloader availableД¬onfiguration error detected (additional info=Modbus register address)Д®rror detected during parameter check (for example, reference velocity value for operating mode Profile Position is greater than maximum permissible velocity of drive).

#GM TECH 2 NO COMMUNICATION SHOWING ERROR SOFTWARE#

The write access level expert is required.Д¬ommand not permissible while power stage is activeД¬ommand not permissible while the power stage is enabled (operating state Operation Enabled or Quick Stop Active).Дisable the power stage and repeat the command.ДЄccess occupied by another channel (for example: Commissioning software is active and fieldbus access was tried at the same time).ДЇile cannot be uploaded: Incorrect file IDДata stored after a power outage is invalid Parameter only accessible at expert level. Write access denied (no access authorization) Write only to parameters that are not read-only.

Parameter write not permissible (READ only) The entered value must be within the permissible value range.Д®rror detected by parameter management: Parameter (index) does not exist.Д®rror detected by parameter management: Parameter (subindex) does not exist. The value entered was outside of the permissible value range for this parameter.

Gm tech 2 no communication showing error